SDI Technologies iP44 Manual de Instruções descarregar pdf (Página 9)

Using the Alarm

Using the Pillow Shaker

The iP44 comes with a pillow shaker that plugs into the aux wake-to (pillow shaker) jack on the back of the unit. You can

wake to any alarm mode with or without the shaker. For example, if your alarm source is set to iPod and the pillow shaker is

connected and on, the iPod will play AND the pillow shaker will vibrate at the set alarm time.

1. Connect the pillow shaker to the aux wake-to (pillow shaker) jack found on the rear of the unit.

2. Slide the pillow shaker power switch to the ON (green) position and place the pillow shaker device under your pillow.

When the alarm goes off, the pillow shaker will vibrate and the alarm source will sound.

3. Slide the switch to the OFF (red) position to turn off the pillow shaker.

4. Press the Snooze Button on the pillow shaker to stop its vibration and silence any alarm source for the duration of

snooze time set (see Snooze Operation) before coming on again.

Setting the Alarm

1. Press and hold the Button until the alarm icon and alarm hour flashes. Press the << or >> Button to set the alarm

hour. Remember to set the correct AM or PM time.

2. Press the Button again. The minutes will flash. Press the << or >> Button to set the alarm minutes.

3. Press the Button again. The wake-to icon will flash. Press the << or >> Button to select iPhone/iPod, radio, aux

(pillow shaker) or buzzer.

Note: if selected wake-to source is iPhone/iPod but no iPhone/iPod is docked/detected, the iP44 will automatically

switch to wake to buzzer. The same is true if the selected wake-to source is aux (pillow shaker) and the pillow shaker is

either turned off or not connected.

4. Press the Button again (or no button within 10 seconds) to exit the alarm setting mode. Two beeps will confirm the

alarm is set and the corresponding alarm icon will light up.

Review, Arming and Disarming Alarm (Turn Alarm Function On and Off)

1. To arm/disarm the alarm, just press the Button to toggle it on or off, indicated by the appearance or lack of the alarm

icon on the display. The current alarm time also appears.

Resetting the Alarm to Come on the Next Day

1. When the alarm is sounding, press the Button to stop the alarm and reset it to come on the following day.

Snooze Operation

1. Press and hold the Snooze/Dimmer Button for a few seconds until the snooze time flashes. Press the << or >>

Button to set the snooze timer for 1 to 29 minutes.

2. Press the Snooze/Dimmer Button on the main unit (or the snooze button on the pillow shaker) after the alarm sounds.

The alarm will be silenced and come on again after the set snooze time. Snooze can be pressed several times during

the 1 hour alarm cycle.

Sure Alarm

The iP44 has a sure alarm feature. If the backup battery is installed, the buzzer alarm will still sound in the event of power

failure.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sem comentários

SDI Technologies iP44 Manual de Instruções Página 9